![]() The extension terminal and the internal magnetic switch can function together to trigger the Door Contact when either of them is activated, you can also choose to disable the internal magnetic switch through JP3 Jumper setting. When the device is triggered the loop is opened, the Door Contact will also be triggered. The extension terminal forms a closed loop with the device connected to it. The Door Contact has an extension terminal to provide enhanced flexibility. If the LED flashes to indicate signal transmission, it will flash twice rapidly upon receiving acknowledgement from panel.When the battery is exhausted, the Door Contact will stop all function, the LED will flash every 4 seconds.When the Door Contact is in Test mode, the LED will light up every time it is activated.When a tamper condition persists, the LED will light on for 2 seconds whenever the Door Contact Is activated. When the cover is opened or the tamper switch is triggered, the LED will light on for 2 seconds. ![]() When the Door Contact battery voltage is low, every time the Door Contact is activated (device opened/ closed), the LED will light on for 2 sec.In Normal Operation Mode, the LED will not light when the Door Contact is activated.In addition to the built-in magnet switch, an additional 2-pin dry contact terminal is provided for an extension magnet switch or any device with N. ![]() Only the device connected to Extension Terminal will activate the Door Contact Jumper Off: if the jumper link is removed or “parked” on one pin.Jumper On: The jumper link is inserted, connecting the two pins.Supervision Jumper Switch (JP2) -Reserved.When Door Contact is mounted, the Tamper switch will be activated when the cover is opened or when the Door Contact is removed from mounted surface. Used to fixed and screw the Door Contact directly onto the Door Frame or Wall. Press the Test button to transmit learning code or enter test mode for 3 min. ![]()
0 Comments
Leave a Reply. |